by Michael Peters
Hardware Requirements
- A single 4-port Ethernet housing such as the Versatap AT44 Surface Jack Housing from Allen Tel Products
- 4 Category 5e modular snap-in jacks such as the AT55 Category 5e Modular Snap-In Jacks from Allen Tel Products
- A small section, about 6 inches, of Category 5e cable
Construction
Figure 1 represents the AT55 Category 5e jack. The wire termination pin positions and associated wire color codes are also shown.
Figure 1: AT55 Category 5e Jack
This diagram is usually included with new Category 5e jacks from any other vendor.
Disassemble the section of Category 5e wire that you have into eight separate wires. These wires should have the same color codes as in Figure 1.
The next step should be to partially assemble the Ethernet housing with the four jacks. These should snap into position easily. Once mounted, begin wiring the first jack position using the solid orange wire. Use the next diagram as a guide. The wires can be inserted with a small screwdriver or some other small flat tool.
Once you have terminated all eight wires, trim off any excess wire that remains. Snap the housing closed, and you should now have a completed passive Ethernet tap (see Figure 2).
Figure 2: Passive Ethernet Tap
Instructions for Use
Note: Keep in mind that when you have a full-duplex Ethernet connection, Tap A will show half-duplex traffic and Tap B will show the remaining traffic. You will need to use two Ethernet interfaces to examine both halves of the full-duplex signal. If you use Sun Trunking software, the traffic can be reassembled. See sun.com for information on Sun Trunking software.
